Single piece shaft stud design CNC Machined from billet 303 Stainless Steel. Unlike a traditional KeyMod Mount, IWC's Bipod Mount is placed through the round hole in the KeyMod pattern and is secured by placing an O-Ring around the shaft against a shoulder on one end, which provides tension against the inside of the handguard while a c-clip placed into a groove machined into the shaft is used to secure the Bipod Mount shaft against the outer surface of the hand guard.

NOTE: Removal of handguard may be required. Single-piece Sling Swivel Stud Bipod Mount design contains no threaded fasteners which can loosen and fail during use. * For better long term secured mounting, use blue thread locking compound on mounting screw thread only.KeyMod Bipod MOUNT-N-SLOT Stud directly attaches to KeyMod forends.Įlegent, minimalistic design and keeps the rail simple and virtually unencumbered by adding only what's needed to attach a bipid requiring a single Sling Swivel Stud to attach to the firearm. * Tighten screws (clockwise) until firmly secured (18-20 in-lbs). This will insure the sling mount hole in the KMSM is lined up correctly with the hole in the KeyMod slot on your handguard, so your swivel will fully seat correctly. * With the KMSM in on the KeyMod rail, and the screws still loose, insert your QD sling swivel into the KMSM. * With supplied Torx wrench, loosen (counter clockwise) the two mounting screws enough so the assembly can drop in and slide forward into the desired mounting position of the rail system. * Locate the forward position of the mount, indicated by the arrow marking, located underneath the sling mount, arrow towards the muzzle.

Requires three KeyMod attachment hole mounting points Low-Profile for increased mobility and decreased 'snag' factorįits standardized KeyMod interface mounting holesįits standard push button, quick detach sling swivel (not included)Ĩ-position (360 ), non-rotational locking interface

Mounting keymod accessories